- Name
- Motion Sensor
- Brand
- devolo
- Documents
- Category Description File Manual_Primary_Lang
- Role type
- ROLE_TYPE_SLAVE_SLEEPING_REPORTING
- Categories
- Sensors
- Product id
- 0x000D
- Device type
- Notification Sensor
- Oem version
- 01
- Library type
- SLAVE_ENHANCED_232
- Supports nwi
- Yes
- Z wave version
- 6.51.02
- Frequency plans
- EU: 869.85MHz, 868.40MHz
- Manufacturer id
- 0x0175
- Product type id
- 0x0002
- Long description
- The Motion Sensor MT02647 has PIR, temperature and illumination, 3 sensors function in one,based on Z-Wave technology.
- Hardware platform
- SD3502
- Short description
- Motion Sensor 3 in 1 (PIR, Temperature and Illumination)
- Association groups
- Group Number Maximum Nodes Supported End Point ID Description 2
- Product identifier
- MT02647
- Countries / regions
- European Union
- Certification number
- ZC10-14090010
- Radio range z wave (m)
- 40
- Configuration parameters
- Parameter Number Name Description Format Size Min Value Max Value Default Value Parameter Values 3
- Supports explorer frames
- Yes
- Controlled command classes
- Identifier Name Key Version COMMAND_CLASS_BASIC
- From to description 0 99 pir level 9 turn off light time after turn on the lighting, setting the delay time to turn off the lighting when the pir motion is not detected. 8 seconds per tick, default tick is 4 (32 seconds). 0 means never send turn off light command. 0 1 0 0 4 from to description 0 127 turn off light time 6 mult sensor function switch multisensor function switch. using bit to control. bit0: reserve. bit1: disable pir integrate illumination to turn on the lighting nodes in the association group 2. (1:disable, 0:enable) bit2: reserve. bit3: reserve. bit4: reserve. bit5: reserve. bit6: reserve. bit7: reserve. notice: the reserve bit is allowed any value, but no effect. 0 1 0 0 4 from to description 2 2 disable pir integrate illumination to turn on the lighting nodes in the association group 2. (1:disable, 0:enable) 4 light threshold setting the illumination threshold to turn on the light. when the event triggered and the environment illumination lower then the threshold, the device will turn on the light. 0 means turn off illumination detected function. and never turn on the light. 1 means darkest. 99 means brightest. 100 means turn off illumination detected function. and always turn on the light. notice: in none test mode, only the value in 1 to 99 will enable the illumination detected function and update the illumination value. 0 1 0 0 99 from to description 0 100 light threshold 8 pir re detect interval time in the normal mode, after the pir motion detected, setting the re detect time. 8 seconds per tick, default tick is 3 (24 seconds). setting the suitable value to prevent received the trigger signal too frequently. also can save the battery energy. notice: if this value bigger than the configuration setting no. 9. there is a period after the light turned off and the pir not start detecting. 0 1 0 0 3 from to description 1 127 pir re detect interval time 2 basic set level setting the basic command value to turn on the light. the 0x ff( 1) means turn on the light. for dimmer equipment 1 to 100 means the light strength. 0 means turn off the light. 0 1 0 0 255 from to description 0 255 basic set value texts
